Product Overview
These pins are used to make the handle of the rolling toolbox quick release so it can easily be removed for loading into a vehicle. They're made from stainless steel so will not go rusty.
To install remove 2 screws at the bottom of the toolbox holding the handle in then slide out the handle, drill out the screw holes in the toolbox to 5.5mm then screw in the pins to the correct depth and tighten. The screw holes in the handle will need to also be enlarged to an 4mm hole to allow the pin to seat.
Video guide for similar pins (not the ones we are selling) can be found in the pictures and video of this listing, the method is the same. (Video credit goes to Electronsmith check out his other packout content!)
Price is for 1 pair of locking pins, no drill bits or packout boxes included.
